I've a panelled long skirt which fits well and I like it so I'm going to try and copy it. I've never done this before so a challenge! I figured if I measured each panel (there's 10 in total) then added the seam allowance it should be straight forward.
Anyone done anything like this before, any tips to avoid a headache?!
Jacky
Kathy, I have done this before
First make sure every panel is the same, the sides maybe different to the front and/or back.
Note what sort of waist band and where the zip is inserted.
If the panels are the same, measure the finished waist and hemline for reference.
Then take each individual panel, measure the top of panel (waistline) and the bottom of panel (hemline) multiply by number of panels, should equal waist measurement and hem line.
If correct, continue with measuring every 10 cm (4") down panel, so that you can then draw the panel side seams at the correct angle. Add the seam allowance to side seams, and either amount to sew into waist band or double if the panel becomes the waist band, however do not continue at an angle, these cutting lines need to be at 90 degrees to the top straight edge of the panel, otherwise you are continuing the decrease and you will not have enough fabric to sew into waist band or make waistband.
The same as the hemline, the extra fabric required to turn for the hem needs to be cut in a straight line otherwise you will have too much fabric to turn under.
Remember that the panels can still be placed on the fold, so you should get a lot of panels on the width of your folded fabric.
I found it easier to cut several pattern pieces the same, so that I could fit as many along the fabric as possible, by pinning several panels onto the fabric I have very little waste (would be better if made my waist smaller to)
Shout if you would like any extra assistance.
Kathy
Thanks Jacky, I'm going to print your reply for my next one. I made one today and sort of did some of the things you mentioned! The skirt ended up too big so I ran the overlocker down the centre panels front and back to reduce it. I didn't need to worry about the hem as I incorporated the finished edge of the material when I cut it out, if you know what I mean. I think the next time I'll make a pattern piece, that should make it easier to cut out.
It's not perfect but fits well and looks fine if you don't look too closely at the finishing! It was made with material that was in my stash and didn't cost anything so a good first attempt.
Jacky
Oh sorry my reply was a bit late Glad your new skirt fits, with a bit of adjustment here and there, but what dressmaking dosen't
